Cisco NCS1004 Manual page 35

Configuring Controllers
LED state: Green On
Maintenance: Enabled
AINS Soak: None
Laser Squelch: Disabled
Phy:
Media type: Not known
Autonegotiation disabled.
Operational values:
Speed: 10Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: Internal
Inter-packet gap: standard (12)
BER monitoring:
Holdoff Time: 0ms
The following is a sample in which the line loopback is configured on the OTU2e controller.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller otu2e 0/0/0/11/3
RP/0/RP0/CPU0:ios(config-otu2e)#secondary-admin-state maintenance
RP/0/RP0/CPU0:ios(config-otu2e)#loopback line
RP/0/RP0/CPU0:ios(config-otu2e)#commit
Thu Apr 23 10:55:19.319 UTC
RP/0/RP0/CPU0:ios(config-otu2e)#end
RP/0/RP0/CPU0:ios#show controllers otu2e 0/0/0/11/3
Thu Apr 23 10:55:28.014 UTC
Port
Controller State
Inherited Secondary State
Configured Secondary State
Derived State
Loopback mode
BER Thresholds
Performance Monitoring
Bandwidth
Alarm Information:
LOS = 0 LOF = 1 LOM = 0
OOF = 1 OOM = 1 AIS = 0
IAE = 0 BIAE = 0
SD_BER = 0
FECMISMATCH = 0 FEC-UNC = 0
Detected Alarms
Bit Error Rate Information
PREFEC
POSTFEC BER
TTI :
FEC mode
Total Duration: 0 hour(s) 0 minute(s)
Remaining Duration: 0 hour(s) 0 minute(s) 0 second(s)
Not supported
SF_BER = 0
BDI = 0 TIM = 0
BER
Remote hostname
Remote interface
Remote IP addr
: OTU2E 0/0/0/11/3
: Up
: Normal
: Maintenance
: Maintenance
: Line
: SF = 1.0E-5 SD = 1.0E-7
: Enable
: 10.0Gb/s
: None
: 0.00E+00
: 0.00E+00
: ios
: OTU2E 0/0/0/11/3
: 0.0.0.0
: STANDARD
Configuring Controllers
Loopback
35