Cisco NCS1004 Manual page 8

Configuring AINS on OTN-XP Card
Laser State: On
LED State: Red
Optics Status
Transceiver Vendor Details
Configuring Controllers
8
Optics Type: 100G QSFP28 LR4
Alarm Status:
-------------
Detected Alarms: None
LOS/LOL/Fault Status:
Alarm Statistics:
-------------
HIGH-RX-PWR = 0
HIGH-TX-PWR = 0
HIGH-LBC = 0
OOR-CD = 0
WVL-OOL = 0
IMPROPER-REM = 0
TX-POWER-PROV-MISMATCH = 0
Performance Monitoring: Enable
THRESHOLD VALUES
----------------
Parameter
------------------------
Rx Power Threshold(dBm)
Tx Power Threshold(dBm)
LBC Threshold(mA)
LBC High Threshold = 98 %
Polarization parameters not supported by optics
Total TX Power = 7.74 dBm
Total RX Power = -40.00 dBm
Lane Laser Bias TX Power
---- ---------- ----------
1 67.2 % 1.85 dBm
2 67.9 % 1.55 dBm
3 67.5 % 1.58 dBm
4 66.8 % 1.89 dBm
Form Factor
Name
Part Number
Rev Number
Serial Number
PID
VID
Date Code(yy/mm/dd)
Fiber Connector Type: LC
Otn Application Code: 4I1-9D1F
Sonet Application Code: Not Set
LOW-RX-PWR = 0
LOW-TX-PWR = 0
HIGH-DGD = 0
OSNR = 0
MEA = 0
High Alarm Low Alarm
---------- ---------
4.9 -12.0
3.5 -10.1
N/A N/A
RX Power Output Frequency
---------- ----------------
-40.00 dBm 231.39 THz
-40.00 dBm 230.59 THz
-40.00 dBm 229.79 THz
-40.00 dBm 230.25 THz
: QSFP28
: CISCO-FINISAR
: 10-3204-01
: B
: FNS20510YUB
: ONS-QSFP28-LR4
: V01
: 16/12/15
Configuring Controllers
High Warning Low Warning
------------ -----------
0.0 0.0
0.0 0.0
0.00 0.00