Cisco NCS1004 Manual page 16

Verifying FEC on OTN-XP Card
From Release 7.3.1 onwards, CFP2-DCO trunk is configured with 0-FEC.
Note The options enhanced SD15 and SD17 are not supported on the OTN-XP card.
To configure FEC on the CoherentDSP controller for the OTN-XP card, use the following command:
configure
controller coherentDSP R/S/I/P
fec OFEC
commit
The following sample shows how to configure O-FEC option on the CoherentDSP controller for the OTN-XP
card:
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/0/0/0
RP/0/RP0/CPU0:ios(config-CoDSP)#fec OFEC
Tue Feb 25 11:25:52.670 UTC
WARNING! Changing FEC mode can impact traffic
RP/0/RP0/CPU0:ios(config-CoDSP)#commit
Verifying FEC on OTN-XP Card
The following sample shows the FEC configuration on the CoherentDSP controller for the OTN-XP card:
RP/0/RP0/CPU0:ios#show controllers coherentDSP 0/0/0/0
Tue Feb 25 11:26:08.235 UTC
Port
Controller State
Inherited Secondary State
Configured Secondary State
Derived State
Loopback mode
BER Thresholds
Performance Monitoring
Bandwidth
Alarm Information:
LOS = 1 LOF = 0 LOM = 0
OOF = 0 OOM = 0 AIS = 0
IAE = 0 BIAE = 0
SD_BER = 0
FECMISMATCH = 0 FEC-UNC = 0
Detected Alarms
Bit Error Rate Information
PREFEC
POSTFEC BER
Q-Factor
Q-Margin
Instantaneous Q_margin
TTI :
Configuring Controllers
16
SF_BER = 0
BDI = 0 TIM = 0
BER
Remote IP addr
: CoherentDSP 0/0/0/0
: Up
: Normal
: Normal
: In Service
: None
: SF = 1.0E-5 SD = 1.0E-7
: Enable
: 50.0Gb/s
: None
: 0.00E+00
: 0.00E+00
: 0.00 dB
: -5.00dB
: 0 dB
: 0.0.0.0
Configuring Controllers