Installing The Second Lcnp4E2 Card - Honeywell T5820XL Installation And Service Manual

Chapter 5 - Servicing
To remove/add memory cards in the workstation
1. Remove the side cover of the workstation.
2. Press the blue retaining tab to remove the memory shroud.
3. Lift the memory shroud upwards to remove it from the system.
4. The DIMM sockets are now exposed. Refer to the section
socket configuration.
5. Wear a grounded ESD wrist strap, press the ejectors on the memory module socket down and
out to remove the memory module from the socket.
6. Insert the new memory module in the socket.
7. Insert the memory shroud and close the side cover.
5.4

Installing the second LCNP4e2 card

5.4.1 Prerequisites
1. Shut down the workstation.
2. Disconnect power from the workstation and disconnect the attached cables.
3. Remove the workstation from furniture.
4. Access the inside of the electronics enclosure.
Memory configuration
- 64 -
for DIMM