Connecting Cables; Connecting Cables To The Workstation - Honeywell T5820XL Installation And Service Manual

Chapter 3 - Installing
3.8

Connecting cables

NOTE
A Local Control Network Processor (LCNP) board and LCN Media Access Unit (MAU) are no
longer used if the Workstation has been upgraded to be an ELCN node.
This section contains instructions for connecting the power cord and cables to the workstation
platform. Your configuration may not have all the card connections.

Connecting cables to the workstation

l
Connect remaining cables and power cables
l
3.8.1 Connecting cables to the workstation
To connect the cables to the workstation
1. Connect a serial device, such as a handheld device, to the serial port. If necessary, the address
for this port can be modified through System Setup.
2. If you have a standard USB keyboard, plug it into a USB port.
3. If you have a standard USB mouse, plug it into a USB port.
4. Use the back USB ports for devices that typically remain connected, such as a printer, mouse,
and keyboard.
5. If you are using SAW USB touchscreens or SAW serial touch screens through USB to serial
connector cable, connect the USB touch screen to USB port.
6. Use the green line-out port to attach headphones and most speakers with integrated
amplifiers. On workstations with a sound card, use the connector on the card.
7. Use the blue line-in port to attach a record/playback device such as a cassette player, CD
player, or VCR. On workstations with a sound card, use the connector on the card.
8. To attach your workstation to a network or broadband device, connect one end of a network
cable to either a network jack or your network or broadband device. Connect the other end of
the network cable to the network adapter port on your workstation. A click indicates that the
network cable has been securely attached.
- 35 -