Honeywell T5820XL Installation And Service Manual page 23

Chapter 3 - Installing
NOTE
A Local Control Network Processor (LCNP) board and LCN Media Access Unit (MAU) are no
longer used if the Workstation has been upgraded to be an ELCN node.
1. Connect the USB mouse and USB keyboard extension cables to the USB connectors.
You can skip this step if you are not using the USB mouse and keyboard.
2. Connect the audio cable from the amplifier to the audio (green) port
3. If you are not using Fault Tolerant Ethernet (FTE), connect the Ethernet cable to the RJ-45
connector on the onboard Network Interface port. This port can be located near the USB ports
at the back of the workstation.
If you are using FTE, connect the FTE cables according to the instructions in the Fault
Tolerant Ethernet Installation and Service Guide.
4. Connect the monitor cables to video adapter.
5. Check the other ends of all the video cables to make sure they are connected to the
appropriate connector on the monitors.
6. If your console has an OEP, connect the serial cable from the OEP adapter to the COM1 port
of the workstation.
7. If LCN MAU is present, and is pre-installed in the treadle area, connect the LCN MAU cable to
the MAU connector on the LCNP4e2 card. If other networks are being used, configure their
MAU and cables appropriately.
8. Connect one or two USB Hub cables to the workstation USB port (s).
9. Connect the workstation power cable to the workstation.
10. Arrange all cables so that the enclosure can be raised and lowered without pinching, jamming,
or straining any cable.
11. The lower valance of the back panel has ten 2 inch holes. These are for both cable passage
and air flow. Four hole plugs are present. Install or move the hole plugs to seal any of the 2
inch holes on the right side of the lower valance that are not used for cable routing. The five 2
inch holes on the left side of the lower valance should be completely open (do not route cable
through these holes) to allow airflow to the front bezel of the workstation.
- 23 -