Honeywell T5820XL Installation And Service Manual page 50

Chapter 5 - Servicing
servicing.
To remove the workstation from a Z or EZ Console
1. From the rear of the console, loosen the fasteners and remove the rear cover.
2. The electronic module sleeve is held in place by detents on the top and bottom of the cover,
near the back edge. Lift the back edge of the cover slightly to allow the top detents to clear the
top of the workstation. You may have to push down on the bottom of the cover as you slide it
toward you and off the workstation.
3. Disconnect the cables that are connected to the back panel connectors of the workstation. Do
not disconnect the peripheral ends of the cables unless specifically instructed to do so. Tag
the cables so that they can be properly reconnected to the workstation.
- 50 -