Honeywell T5820XL Installation And Service Manual page 27

Chapter 3 - Installing
6. Install the left retaining bracket over the lower edge of the side mounting rail as displayed in
the figure. Make sure the distance between the back panel of the workstation and the lip of
the rear cover retaining bracket is five (5) inches as illustrated in the previous image.
7. Secure the right and left bracket by tightening the M5 hex locknut as illustrated in the
following image.
8. Route the interface cables into the cable management area at the rear of the workstation. The
following image illustrates how interface cables are terminated to their respective connectors
on the rear of the workstation chassis. Any excess length is managed in the 127 mm [5 inch]
space behind the chassis.
- 27 -