Table of Contents
Advertisement
3. Remove the adhesive from the air gasket ("L" shaped foam) and place it on top of the
workstation as shown in the following "Air flow and air dam arrangement" figure. The adhesive
keeps the gasket in place. The gasket stops the exhaust air from re-circulating around the
workstation.
4. Remove the adhesive from the air dam (clear flat sheet with two chamfered corners). Cover
the ventilation slots at the bottom of the electronic enclosure near the front side of the
workstation, with the chamfers downward. For this workstation, the ventilation slots are at the
right side. The dam causes cooling air to be drawn down from the back panel area (refer to the
following Air flow and air dam arrangement figure).
5. Test that the electronics enclosure can be closed and opened without binding. With some
workstations, it may be necessary to trim or augment the air gasket.
Connect system cables
l
3.3.2
Connect system cables
To connect system cables
Figure 3.1 Air flow and air dam arrangement
- 22 -
Chapter 3 - Installing
Hide quick links:
Advertisement
Table of Contents
