Replace/Add The Power Adapter Card - Honeywell T5820XL Installation And Service Manual

5. Insert the new video card in the same PCIe slot 2, as illustrated in the following image.
6. Replace the cardholder and ensure that the tab locks in its place.
7. Replace the workstation cover and place the workstation in the furniture. Refer to the section,
Installing
5.3.2

Replace/add the power adapter card

The power adapter card is located in the PCI slot 6 in the workstation.
Prerequisites
Refer to the section,
access the power adapter card in the PCI slot 6.
1. Shut down the workstation.
2. Disconnect power from the workstation and disconnect the attached cables.
3. Remove the workstation from furniture.
4. Access the inside of the electronics enclosure.
5. Disconnect cables from the card being replaced.
ATTENTION
Do not mix flat panel displays and CRTs is a multi-screen configuration on a single
platform.
for installing the workstation in the furniture.
Accessing the enclosure of the workstation and perform the following to
- 59 -
Chapter 5 - Servicing