Honeywell T5820XL Installation And Service Manual page 25

Chapter 3 - Installing
1. From the rear of the console, loosen the two fasteners on the rear cover. Remove the rear
cover and set it aside. A different workstation is illustrated in the following image.
2. Slide the furniture bay cover off the mounting railings.
3. The following illustrates how cables in the left leg and right leg of a Z/EZ-console (when
viewed from the rear of the console) are routed through the left and right module mounting
bracket.
ATTENTION
Earlier workstation platforms installed in Z/EZ-consoles used a cable management
bracket, P/N 51405057-100, that are installed under the auxiliary power supply
compartment of the Z/EZ-console base structure. This cable management bracket
is NOT used when installing Dell Precision T5820XL workstation in Z/EZ-consoles.
Instead, cables are held in position by four (4) ribbon cable clamps, P/N
51103230-203, adhered to the inside surface of the left and right module
mounting bracket.
4. Place the workstation on the mounting rails. The following illustrates a Dell T5820XL-based
workstation installed in the Z-console module mounting brackets. You can slide the
workstation chassis in place between the four (4) ribbon cable clamps. The four cable clamps
act to restrain the workstation from the sideward movement.
- 25 -