Chapter 5 - Servicing; Accessing The Enclosure Of The Workstation; Shutdown Workstation; Remove The Workstation From A Z Or Ez Console - Honeywell T5820XL Installation And Service Manual

CHAPTER
5
NOTE
A Local Control Network Processor (LCNP) board and LCN Media Access Unit (MAU) are no
longer used if the Workstation has been upgraded to be an ELCN node.

Accessing the enclosure of the workstation

l
Servicing the LCNP4e2
l
Replacing/adding optional components
l
Installing the second LCNP4e2 card
l
Verifying BIOS settings
l
5.1 Accessing the enclosure of the workstation
This section contains procedures for removing the workstation from a Z or EZ console, and a
cabinet. The procedures apply to the workstation.

Shutdown workstation

l

Remove the workstation from a Z or EZ Console

l
Remove the workstation from a Cabinet
l
Remove the workstation from an Icon Series console
l
Remove workstation from LCN cabinet
l
Open the enclosure
l
5.1.1 Shutdown workstation
The following workstation shutdown procedure is applicable to workstations mounted in a Z or EZ
Console or cabinet.
1. Perform a double SHUTDOWN of the native window and a SHUTDOWN of the Windows
operating system. Refer to the Global User Station User's Guide for instructions.
2. When the RESTART message appears on the monitor, place the Power Entry breaker in the
OFF position (applicable to consoles only).
3. Turn off power to the computer if it has a separate power switch, and disconnect the AC
power cord.
4. Turn off power to the monitor(s) and the printer, if applicable.
5.1.2 Remove the workstation from a Z or EZ Console
If the workstation is mounted in the Z or EZ Console, remove it from the furniture before
S
ERVICING
- 49 -