Table of Contents
Advertisement
Products in the AMAX-1220/1240 Series are used to increase the number of axes for
an AMONet RS-485 distributed motion control network. These extension slave mod-
ules connect serially by a simple and affordable Cat.5 LAN cable, reducing the wiring
between driver and controller. This is very suitable for highly integrated machine
automation applications.
AMAX-1220 and AMAX-1240 support a range of common motor vendors by transfer
cable, such as Mitsubishi J3-Super series, Panasonic Minas A4 or A5 type, and Yas-
kawa Sigma-V.
1.1
Features
End limit logic is switchable (high or low active)
Board ID is switchable
Easily visible LED indicators on board to do diagnosis
Direct wire to servo drive to save terminal board space while installation
Max. 6.5 MHz, 4-axis pulse output
28 bits counter for incremental encoder
Horizontal installation for for servo or stepping motor driver
Suitable for DIN-rail mounting
Linear & Circular interpolation support for AMAX-1220/1240
Simultaneously start / stop between modules are supported for AMAX-1220 and
AMAX-1240
Position compare and triggering function is supported for AMAX-1240 by linear
interval & table list method
1.2
AMAX-1220 Specification
1.2.1
Axes
Number of Axes 2 Axes
Driver Output
Pulse
2~32-Axes Linear
Interpolation
2-Axes Circular
Interpolation
AMAX-1220/1240 Series User Manual
Position control Range
Acceleration/
Deceleration
Driver Speed
Pulse Output Type
Counter
Precision
Output Signal Modes
Speed Curve
Range
Speed
Precision
Range
Speed
Precision
2
-134,217,728 ~ +134,217,728
1 to 65,536(16-bits)
Max: 5 Mpps
Min: 0.1 pps
Pulse/Direction(1-pulse, 1-direction type) or Up/
Down(2-pulse type) or A/B phase
Counter1: Command position counter
Counter2: Mechanical position counter
Counter3: General-purpose deviation counter
0.5LSB
Differential line driving output
T/S-curve Acceleration/Deceleration
-134,217,728 ~ +134,217,728
0.1~5Mpps
0.5LSB
-134,217,728~+134,217,728
0.1~5Mpps
0.5LSB
Advertisement
Table of Contents
