Table of Contents
Advertisement
3.
Manual Operation
3.1
Introduction
The DC power supply can be operated manually or remotely via GPIB/CAN (option) or USB
or APG interface which is described in Chapter 5 and section 3.2.4.1. Refer to the manual
operation for using the front touch panel or rotary knob to input data described in this
chapter.
The operation mode defaults to manual mode whenever power to the
supply is turned on.
3.2
Menu for Setup
The Menu provides you various settings for configuring the system functions of DC power
supply. The functions include:
1. Meas. & Setup :
2. Output Setup
3. System Setup
4. Program Seq.
5. Advance
6. Configuration
The Menu screen is shown in Figure 3-1 with a complete function tree as shown in Figure
3-2.
To set output voltage, current and power parameters.
:
To set various output parameters including voltage/current slew rate
and etc.
:
To set the display panel, various protections, time and factory
defaults.
:
To set LIST MODE & V_STEP MODE.
:
To set advanced functions (not supported yet).
:
To set the communication interface, serial/parallel settings, power on
status, and calibration.
Figure 3-1
Manual Operation
3-1
Advertisement
Table of Contents
