Chroma 62000D Series Operating And Programming Manual page 141

Return Example:
11. CONFigure:BRIGhtness
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter:
Query Example:
Return Example:
12. CONFigure:MSTSLV:ID
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter:
Query Example:
Return Example:
Note CONFigure:MSTSLV? must be OFF when setting it. (Not in series/parallel mode.)
13. CONFigure:MSTSLV:PARSER
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter:
Query Example:
Return Example:
Note CONFigure:MSTSLV? must be OFF when setting it. (Not in series/parallel mode.)
14. CONFigure:MSTSLV:NUMSLV
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter:
Query Example:
Return Example:
Note 1. CONFigure:MSTSLV? must be OFF when setting it. (Not in series/parallel mode.)
Only 1 slave can be set when in series mode and maximum 3 slaves can be set
2.
when in parallel mode.
Keypro is required for series connection, so be sure to connect it first in series mode.
3.
Release and remove the keypro when operating standalone or in parallel mode.
FIX
Sets the display brightness of panel.
CONFigure:BRIGhtness <Arg>
<Arg>: HIGH | NOR | DIM
CONFigure:BRIGhtness HIGH
CONFigure:BRIGhtness?
HIGH | NOR | DIM
CONFigure:BRIGhtness?
HIGH
Sets the device to Master. This command is not required for the
Slave device.
CONFigure:MSTSLV:ID <Arg>
<Arg>: MASTER
CONFigure:MSTSLV:ID MASTER
CONFigure:MSTSLV:ID?
MASTER | SLAVE1 | SLAVE2 | ...... | SLAVE9
CONFigure:MSTSLV:ID?
MASTER
Sets to series or parallel mode. Both Master and Slave need to be
set by this command.
CONFigure:MSTSLV:PARSER <Arg>
<Arg>: PARALLEL | SERIES
CONFigure:MSTSLV:PARSER PARALLEL
CONFigure:MSTSLV:PARSER?
PARALLEL | SERIES
CONFigure:MSTSLV:PARSER?
PARALLEL
Sets the number of SLAVE to be controlled. This command is not
required for the Slave device.
CONFigure:MSTSLV:NUMSLV <NR1>
<NR1>
CONFigure:MSTSLV:NUMSLV 1
CONFigure:MSTSLV:NUMSLV?
<NR1>
CONFigure:MSTSLV:NUMSLV?
1
Remote Operation
5-15