Chroma 62000D Series Operating And Programming Manual page 22

Programmable Bidirectional DC Power Supply 62000D Series
Operating and Programming Manual
Programming
&Measurement
Resolution
Voltage (Front Panel )
Current (Front Panel)
Voltage (Digital
Interface)
Current (Digital
Interface)
Voltage (Analog
Interface )
Current (Analog
Interface )
Remote Interface
Analog programming
USB
GPIB
CAN
LXI Compliant LAN
Interface
Programming
Accuracy
Voltage (Front Panel
and Digital Interface )
Current (Front Panel and
Digital Interface )
Power (Front Panel and
Digital Interface)
Voltage (Analog
Interface)
Current (Analog
Interface)
APG Measure
Accuracy
Voltage (Analog
Interface)
Current (Analog
Interface)
GPIB Command
Response Time
Vout setting
Measure Volt & Current
Analog Interface (I/O)
Voltage and Current
Programming inputs
(I/P)
Voltage and Current
monitor output (O/P)
External ON/OFF (I/P)
DC_ON Signal (O/P)
CV or CC mode
Indicator (O/P)
OTP Indicator (O/P)
1-4
GPIB send command to DC source receiver <20ms
Under GPIB command using Measure <25ms
Current: Source I = 0 - 10Vdc of F.S.
Voltage: 0 - 10Vdc of F.S.
Current : -10 - 10Vdc of F.S.
TTL: Active Low or High (Selective)
Level by user defined. (Time delay= 1ms at voltage slew rate of
TTL Level High=CV mode;
TTL Level Low=CC mode
10mV
10mA
0.002% of Vmax
0.004% of Imax
0.04% of Vmax
0.04% of Imax
Standard
Standard
Optional
Optional
Standard
0.05% of Vmax
0.2% of Imax
0.3% of Pmax
0.2% of Vmax
0.3% of Imax
0.5% of Vmax
0.75% of Imax
Voltage: 0 - 10Vdc of F.S.
Load I = 0 - 10Vdc of F.S.
10V/ms.)
TTL: Active Low