Bosch Rexroth IndraControl S20 Manual page 62

60/82 Bosch Rexroth AG
Technical data and ordering data
Supply voltage U (actuators)
O
Undervoltage detection
Diagnostics indicators
External protection
Safe digital outputs
Number
Supply
Maximum output current per output (channel)
Maximum output current for all outputs (total current)
Maximum output current for each group (total current)
Group 1 (OUT0_K1, OUT1_K1, OUT2_K1, OUT3_K1)
Group 2 (OUT0_K2, OUT1_K2, OUT2_K2, OUT3_K2)
Maximum output voltage in the low state
WARNING
The use of unsuitable power supplies can result in the loss of the safety function.
• Only use power supplies according to EN 50178/VDE 0160 (PELV) for the voltage supply to the bus coupler.
• Make sure that the output voltage of the power supply for the bus coupler does not exceed 32 V even in the event of an
error.
• Observe the general safety notes: see
Maximum leakage current in the low state
WARNING
Switching the load at the maximum leakage current can result in the loss of the safety function.
• Please note that at this current, the load must not be switched or remain in the ON state.
• Please take this into consideration when selecting the actuator.
Minimum withstand voltage of the connected loads
WARNING
Switching the load at the minimum withstand voltage can result in the loss of the safety function.
• Please note that at this voltage, the load must not be switched or remain in the ON state.
• Please take this into consideration when selecting the actuator.
Maximum inductive load
Maximum capacitive load
Minimum load
Limitation of the voltage induced on circuit interruption
IndraControl S20 Module With Safe Digital Outputs S20-PSDO-8/3
Yes, at approximately 17 V
Green U
See
8 A slow-blow, maximum
4 two-channel or 8 single-channel (positive switching)
From supply voltage U
2 A
1.5 A (according to CUL
8 A
6 A (according to CUL
4 A
3 A (according to CUL
4 A
3 A (according to CUL
<5 V
Loss of safety function
"Electrical safety" on page
2 mA
Loss of safety function
>5 V
Loss of safety function
1 H
10 µF per channel
10 µF in total
1.5 k (16 mA at 24 V)
-15 V
DOK-CONTRL-S20*PSDO*8*-AP02-EN-P
LED:
O
"Local diagnostics and status indicators" on page
O
)
US
)
US
)
US
)
US
8.
15.