Disassembly Of The Track Mount Before Installation; Figure 24: End Plate Removal - Nuvo VISTOR Installation & Service Manual

Disassembly of the Track Mount before Installation

Note: For installations where there are two existing trolley assemblies on a single
track (Dual Trolley Model No. 044012), the left and right trolley must be removed from the
track from their respective sides. When disassembling the track, remove both end plates
from the unit. Remove the right trolley from the right side and the left trolley from the left
side of the track.
Do not mix the right and left trolley assemblies. The cord bracket within each trolley
is positioned to make electrical connection for the right and left light fixtures
respectively. Nuvo, Inc. recommends temporarily marking each trolley if needed to make
sure these are assembled onto the track in the proper location and orientation.
When performing this procedure DO NOT disassemble the components of the
trolley assembly or remove the track extrusion channel from the plywood pallet.
• Take the end plate/plates P/N1001511 off the side of the track by unfastening the two (2) #6
wood screws. See figure 24.
Wood Screws
End plate

FIGURE 24: End Plate Removal

5368 KUHL ROAD ● ERIE, PENNSYLVANIA 16510 ● PHONE 814-899-4220 ● FAX 814-899-1410
A member of the Medical Illumination International Group
Section 3
Plywood Pallet
P
age 41 of 85