Table of Contents
Advertisement
Cable
Assembly
Ceiling
Rod
FIGURE 4: Sub-Assemblies for Single Ceiling Mount
Installation and repair of this equipment should be performed by qualified persons
only. Nuvo does not warranty any damage occurring as a result of improper installation.
The shipping cartons contain a light head assembly, an arm assembly, a ceiling casting, casting
cover, collar, bolt cover, ceiling rod, hardware kit, wire harness, and an Installation and Service
Manual.
Notes: There are 3 standard length rods for different ceiling heights. Extended ceiling rod kits are
available for ceilings over 10' 6". Verify that your ceiling rod length is correct for your ceiling height
(see pages 21-23). If not correct please contact customer service.
Prior to installation insure that all components shown in figure 4 are present.
When removing parts from the shipping carton, be careful not to damage the
components or break any glassware. Important: thoroughly check each box for parts that
may be located in areas that can be overlooked.
Note: The VistOR EX & EXL Light is shown for reference.
5368 KUHL ROAD ● ERIE, PENNSYLVANIA 16510 ● PHONE 814-899-4220 ● FAX 814-899-1410
Single Ceiling Mount Installation
Ceiling
Casting
Assembly
GENERAL INFORMATION
A member of the Medical Illumination International Group
Light
Head
Assembly
Arm
Assembly
Section 3
Page 21 of 85
Advertisement
Table of Contents
