Table of Contents
Advertisement
Ceiling Mount Pre-Installation Guidelines
SPECIAL NOTE: Installation and repair of this equipment should be performed by qualified
persons only. Nuvo, Inc. does not warranty any damage occurring as a result of improper
installation.
It is recommended that this installation manual be completely reviewed prior to installation.
Before installation, check to insure the following minimum conditions are provided:
• The structural ceiling mount should be designed to support a vertical load of at least 100 lbs.
and an off center moment of 300 ft-lbs. The structural mount should meet all local building
codes.
A structural mount that does not meet these minimum conditions can cause serious
injury and/or property damage.
• It is recommended that the equipment be mounted directly over a 4-0 junction box. If this is not
possible the input power supply lines should be wired in accordance with all applicable building
codes.
• The supply circuit line must be as follows:
120 VAC lights: 110 -120 VAC 60 Hz, single phase, three wire, capable of supplying 700 Watts
@ 7 Amperes.
220 VAC lights: 230 -240 VAC, 50/60 Hz, single phase, three wire, capable of supplying 700
Watts @ 3.5 Amperes.
• The power supply circuit line must be routed and wired to the light head in compliance with all
applicable building codes.
Failure to provide a circuit meeting these minimum standards or complying with local
building codes can cause a shock hazard.
•
Check the length of the ceiling rod supplied to make sure that it is the proper length to install
and operate the light without interference or over reach.
(See ceiling Rod Calculation pages 21-23)
5368 KUHL ROAD ● ERIE, PENNSYLVANIA 16510 ● PHONE 814-899-4220 ● FAX 814-899-1410
Installation/Assembly
A member of the Medical Illumination International Group
Section 3
Page 16 of 85
Advertisement
Table of Contents
