Arm Assembly To Upright Pole Installation; Figure 16: Arm Assembly To Upright Pole Installation - Nuvo VISTOR Installation & Service Manual

Arm Assembly to Upright Pole Installation

Transformer
Housing
Molex
Connectors
Mounting Bolts
P/N 0001291

FIGURE 16: Arm Assembly to Upright Pole Installation

• While securely supporting the extension arm above the upright pole, firmly grasp the cable at
the end of the pole. DO NOT allow the cable to slip into the pole as it may be difficult to retrieve
it. Connect the Molex connector from the transformer housing to the connector at the end of the
pole. Remove the cable tie holding the harness in place and discard it. Carefully lower the
extension arm and insert the transformer housing while pushing the wiring into the pole. Secure
the housing to the pole utilizing the two ¼"-20 x
• The light arm should be between the extended legs as shown in figure 16.
• To level the base, remove the end caps at the end of each leg and adjust the caster bolts and
nuts. Once the base has been leveled, tighten the nuts securely and insert the leg cap in the
end of each leg. See figure 15.
• See the instructions for "Installation of Light Head to Arm" on page 40.
5368 KUHL ROAD ● ERIE, PENNSYLVANIA 16510 ● PHONE 814-899-4220 ● FAX 814-899-1410
A member of the Medical Illumination International Group
3
/ " bolts supplied. Tighten the bolts securely.
8
Section 3
Extension
Arm
Page 35 of 85