Konica Minolta REGIUS 190 Service Manual page 69

2.3 Insertion / Ejection Unit
8.
Remove an E-ring, and remove drive gear x 1, parallel pin x
1, shaft bearing "B" x 1 from the left of the roller shaft.
9.
Remove an E-ring, and remove shaft bearing "B" x 1 from
the right of the roller shaft.
10.
Remove the insertion roller (front).
11.
Remove E-rings (one on each side) from the both shaft
ends, and remove the insertion roller (rear).
12.
Carry out reassembly in the reverse order to that described
above.
42
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Insertion Roller (Front)
Parallel
Pin
E-Ring
Drive Gear
Insertion Roller (Rear)
E-Ring
E-Ring
Bearing "B"
Bearing "B"
E-Ring