Mechanical Control Error Codes - Konica Minolta REGIUS 190 Service Manual

4.4.2

Mechanical Control Error Codes

04001 ~ 04069 indicates an error occurred on the sensors.
Error Error name
code
Feed HP sensor NG
04001
Feed Escape Position
04011
sensors NG (at initial-
ization)
Feed Escape Position
04012
sensors NG (while
moving to absorption
position)
Feed Escape Position
04013
sensors NG (while
moving to escape
position)
Feed Escape Position
04014
sensors NG (while
moving to eject posi-
tion 1)
Feed Escape Position
04015
sensors NG (while
moving to eject posi-
tion 2)
04021 Justification R/L sen-
sor NG (at reading)
Error description
A time-out occurred for ON or OFF
detection by the Feed HP sensor
while the transport unit is moving
to its receiving position.
A time-out occurred for ON detec-
tion by the Feed Escape Position
sensor while the transport unit is
moving to escape position.
1) The Feed Escape Position sen-
sor was already ON at the start
of motion by the transport unit
from the receive position to the
absorption position.
2) A limit-over occurred for ON
detection by the Feed Escape
Position sensor during motion
by the transport unit from the
receive position to the absorp-
tion position.
A limit-over occurred for OFF
detection by the Feed Escape Posi-
tion sensor during motion by the
transport unit from the absorption
position to the escape position.
A limit-over occurred for OFF
detection by the Feed Escape
Position sensor during motion by
the transport unit from the absorp-
tion position to the escape posi-
tion.
During motion by the transport unit
from the absorption position to the
eject position, ON --> OFF detec-
tion by the Feed Escape Position
sensor occurred within 70 mm
from the absorption position.
1) The Justification Sensor was
OFF after the completion of jus-
tification operation during cas-
sette intake.
2) The justification sensor was
OFF after closing of the inser-
tion slot shutter during cas-
sette take-in.
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Action
Check MCB2:CN11-, pins 32 through 34
(HP sensor) and MCB2:CN15 (Trans-
portation Motor)
Check MCB2:CN11-, pins 35 through 37
(Feed Escape Position sensors) and
MCB2:CN15 (Transportation Motor)
Check MCB2:CN11-, pins 35 through 37
(Feed Escape Position sensors) and
MCB2:CN15 (Transportation Motor)
Check MCB2:CN11-, pins 35 through 37
(Feed Escape Position sensors) and
MCB2:CN15 (Transportation Motor)
Check MCB2:CN11-, pins 35 through 37
(Feed Escape Position sensors) and
MCB2:CN15 (Transportation Motorr)
Check MCB2:CN11-, pins 35 through 37
(Feed Escape Position sensors) and
MCB2:CN15 (Transportation Motor)
• Check MCB2:CN11-, pins 9 through
11 (Justification Sensor- L);
MCB2:CN11-, pins 12 through 14
(Justification Sensor-R); and
MCB2:CN17 (Justification Motor)
• Check the loose of the drive pulley
Refer to "2.4.3 Replacement of the
Justification Motor (PM2), p.55"
"3.8 Checking and Adjusting the
Justification Allowance, p.124"
4.4 Error Code
and
151