Mitsubishi MELFA 4D-2CG5100-PKG-E Instruction Manual page 42

6 Vision Sensor Settings
(6) Input the vision sensor [New Name] (host name) and [New IP], then click the [Next] button.
Check with your network administrator for the IP address to set.
Here is an example in which an IP address of "10.50.0.100" is set.
(7) Click the [Configure] button, cut off the power for the vision sensor, wait at least 5 seconds, then
switch the power back on again.
(8) When "Settings complete" is displayed in the [Status] column, the settings are complete. Finally click
the [Close] button to close the screen.
6-31 Vision Sensor Initial Settings