Linhai ARCHON 400 Service Manual page 165

CHAPTER 6 TRANSMISSION
broken teeth.
14. Remove seals from transmission case.
IMPORTANT: New seals should be installed after
the transmission is completely assembled.
15. Inspect bearings for smooth operation. Check for
excessive play between inner and outer race.
6.8 TRANSMISSION
1. Install sprocket on front output shaft with
sprocket step side inward as shown (only for
4X4).
2. Assemble front ( only for 4X4).and rear output
shafts
3. a. (4X4) Install front and rear output shafts with
chain as an assembly.
b. (2X4) Install rear output shaft.
4. Before installing the cover make sure the sealing
surfaces are clean and dry, and shafts are fully
seated in the transmission case. Apply silicon glue
to mating surfaces.
5. Reinstall cover and torque bolts in a crisscross
pattern in 3 steps to 14 ft. lbs. (20 Nm).
6. Install new front ( only for 4X4) and rear output shaft
seals.
ASSEMBLY
BUCK 450 SERVICE MANUAL 20.0
CHAPTER 6 TRANSMISSION PAGE. 6- 9