CHAPTER 3 ENGINE
BUCK 450 SERVICE MANUAL 20.0
CAUTION:
Use the spacer (30mm, thickness: 2-3mm).
6. Install:
V-belt
Clutch assembly
NOTE:
Install the V-bet with clutch assembly to the
primary sheave side.
CAUTION:
Never smear grease to the V-belt, secondary
sheave and clutch.
7. Install:
Nut (clutch carrier)
NOTE:
Tighten the nut (clutch carrier), using the locknut
wrench while holding the clutch carrier with
the rotor holder
8. Install:
Clutch housing
Nut (clutch housing)
NOTE:
Tighten the nut (clutch housing),using the
sheave holder ).
9. Set:
V- belt
NOTE:
Move the V-belt to minimum diameter of the
primary sheave , maximum diameter of the
secondary sheave and make the V-belt tense.
CHAPTER 3
ENGINE
PAGE. 3- 45