Linhai ARCHON 400 Service Manual page 139

CHAPTER 5 FINAL DRIVE
1. Remove the bevel gear-driving Ⅰ， the adjust
shim J and the O-ring K.
Remove the bearing retainer L with the
special tool.
Remove the bearing M and the oil seal P
from the bevel gear bearing housing N.
→Fig 4
Fig 3
BUCK 450 SERVICE MANUAL 20.0
2. Remove the six bolts M8×25 Q and the two
bolts M10×1.25×25 R.
Remove the ring gear bearing housing T from
the rear gear case S.
→Fig 5
3. Remove the oil seal 65×90×9 U from the rear
gear case S.
Remove the needle bearing V from the rear
gear case S.
→Fig 6
CHAPTER 5
Fig 4
Fig 5
FINAL DRIVE. 5- 17