Linhai ARCHON 400 Service Manual page 177

CHAPTER 7 BRAKES
Use care when supporting vehicle so that it does not
tip or fall. Severe injury may occur if machine tips or
falls.
2. Remove the front wheel.
3. Remove the two caliper bolts and caliper from
mounting bracket.
4. Push caliper piston into caliper bore slowly using
a C-clamp or locking pliers with pads installed.
NOTE: Brake fluid will be forced through
compensating port into master cylinder fluid
reservoir when piston is pushed back into caliper.
Remove excess fluid from reservoir as required.
5. Push mounting bracket inward and slip outer
brake pad past edge. Remove inner pad.
INSPECTION
Measure the thickness of the pad friction material.
Replace pads if worn beyond the service limit.
Service Limit 0.3/64"(1 mm)
INSTALLATION
1. Lubricate mounting bracket pins with a light film
BUCK 450 SERVICE MANUAL 20.0
CHAPTER 7 BRAKES PAGE. 7- 8