Linhai ARCHON 400 Service Manual page 179

CHAPTER 7 BRAKES
difference between measurements
3. Mount dial indicator as shown to measure disc
runout on the dial indicator. Replace the disc if
runout exceeds specifications.
Brake Disc Runout
Service Limit 0.005" (0.127 mm)
REMOVAL/ REPLACEMENT
1. Removal caliper and hub. Apply heat to the hub
in the area of the brake disc mounting bolts to
soften the bolt locking agent.
2. Remove bolts and disc.
3. Clean mating surface of disc and hub.
4. Install new disc on hub and tighten to specified.
CAUTION:
Always use new brake disc mounting bolts.
Front Brake Disc Mounting Bolt Torque :
18 ft. lbs. (25 Nm )
7.11 FRONT CALIPER REMOVAL/ INSPECTION / INSTALLATION
CAUTION:
The caliper is a non-serviceable component; it must
be replaced as an assembly.
NOTE: If any special service needed, contact the
CUV manufacture via the agent for the parts and
special instruction.
REMOVAL
1. Remove wheel, remove caliper from the strut.
2. Loosen and remove brake hose to caliper. Place
a container under caliper to catch fluid draining.
INSPECTION
Inspect caliper body for nicks, scratches or worn.
BUCK 450 SERVICE MANUAL 20.0
CHAPTER 7 BRAKES PAGE. 7- 10