Nc Parameters - Hiwin TM-2 Series Installation Manual

MW99UE01-2104
Torque Motor Installation Manual
Failed axis(swivel, rotary table, brush, ...):___________________________________________
Failure message form the Controller: □ No / □ Yes, message: ________________________
____________________________________________________________________________
□ Sudden stop, comments:_____________________________________________________
□ Performance degradation (vibration, ripple, noise), comments:________________________
_________________________________________________________________________
□ Other, comments:___________________________________________________________
_________________________________________________________________________
Did the same failure occur before?
□ No / □ Yes, when exactly(

7.2.4 NC parameters

□ NC(Numerical Control) type: __________________________________________________
□ Other comments:___________________________________________________________
List all parameters regarding to the motor, or send the corresponding file to HIWIN (in case
HIWIN supplied the parameter data sheet for the motor, please send HIWIN this parameter file)
____________________________________________________________________________
____________________________________________________________________________
A. Filter type: □ Harmonic filter □ Regen filter □ EMC filter □ Other type _______ □ No
B. Chokes & Reactors: □ Line reactor □ Commutation choke □ Other type _______ □ No
C. Power supply types: _______
D. Amplifier types: _______
E. Chokes & Reactors: □ dv/dt reactor □ Motor choke □ Other type _______ □ No
F. Filter type: □ dv/dt filter □ sinusoidal filter □ Other type _______ □ No
G. Short circuit relay type: _______, □ No
H. THPD used? □ No / □ Yes
7-8
yyyy-mm-dd
):___________, failure motor type:_____________
Maintenance and Troubleshooting
HIWIN MIKROSYSTEM Corp.