Table of Contents
Advertisement
Torque Motor Installation Manual
1.3.8 Wiring precautions
1.
Before using the product, carefully read through the specification noted on product label, and ensure
the product is used with power supply specified in product requirement.
2.
Check if the wiring is correct. Incorrect wiring may make the motor operate abnormally, or even
cause permanent damage to the motor.
3.
Select extension cord with isolation net. The isolation net must be grounded.
4.
Do not connect power cable and temperature sensor cable to the same extension cord.
5.
Power cable and temperature sensor cable contain isolation net. The isolation net must be
grounded.
1.3.9 Operation precautions
1.
Avoid excessive friction when the motor is running.
2.
Ensure there is no object in the motion range of the system.
3.
Before starting the motor, ensure the water cooling system works properly.
4.
Before starting the motor, ensure the main switch is on.
5.
Before transmitting electricity, ensure at least one ground wire is connected to all electrical products.
6.
Do not directly touch motor parts after motor is assembled.
7.
If the current exceeds the maximum specified current, magnetic components in the motor may be
demagnetized. When it happens, please contact HIWIN or local distributors.
8.
Do not operate the product in an environment that exceeds its rated load.
9.
When the motor is running, its temperature must be within the specification.
10. If any abnormal odor, noise, smoke, temperature rise or vibration is detected, stop the motor and turn
off the power immediately.
11. Fixed operation environment conditions must comply with EN 60721-3-3 (Please refer Table 1.3 on
the next page)
HIWIN MIKROSYSTEM Corp.
MW99UE01-2104
Introduction
1-9
Advertisement
Table of Contents
Troubleshooting
