Maintenance And Storage Precautions - Hiwin TM-2 Series Installation Manual

Torque Motor Installation Manual

1.3.10 Maintenance and storage precautions

1. Do not store the product in an inflammable environment or with chemical agents.
2. Store the product in a place without humidity, dust, harmful gases or liquids.
3. Install the product in location with less vibration.
4. The way to clean the product: wipe with alcohol (70%)
5. The way to discard the damaged product: recycle it according to local laws and regulations.
6. Storage conditions must comply with EN 60721-3-1(Refer Table 1.4 on the next page)
7. Motor can be stored for up to two years indoor with the following conditions:
i. Dry
ii. Dust-free
iii. No vibration
iv. Good ventilation
v. Resistance to extreme weather
vi. Indoor air does not contain corrosive gas
vii. Prevent motor vibration and moisture
8. If no dry storage environment is available, the following measures need to be taken:
i. Wrap the motor with moisture-absorbing material, and then seal the motor.
ii. Put desiccant in the sealed package; the desiccant needs to be checked and replaced if
necessary.
iii. Check the motor regularly.
9. After long-term storage and removal of the motor, the insulation resistance value may be reduced
due to moisture. Before installing the machine, confirm the insulation resistance state of the motor.
Use an inspection instrument that meets EN61557. The test must reach 100MΩ after 60 seconds at
1000�� . If it does not meet the specifications, the motor may be damp. If it is used directly, it may
����
cause insulation damage. You can dehumidify the motor by yourself. The steps are as follows or
please contact HIWIN:
i. Put the motor in the oven, set the temperature to 70℃ (the maximum temperature should not
exceed 80℃), take it out after four hours, and put it at room temperature.
Measure the insulation resistance, if it does not reach 100 MΩ, repeat the process i (at this time,
ii.
pay attention to whether the insulation resistance has gradually increased, if it cannot be
improved, please contact HIWIN).
HIWIN MIKROSYSTEM Corp.
MW99UE01-2104
Introduction
1-11