MW99UE01-2104
Torque Motor Installation Manual
Motor Interface Design
4.3 Stator interface design
The recommended tolerance of housing's inside diameter and stator's mounting holes is H7 or H8, and
Table 4.7
the recommended flatness specification of stator mounting level (Flatness B) is given in
.
Housing is suggested to be chamfered, deburred and rounded (the recommended dimension is shown in
Figure 4.9
) to avoid scratching O-ring and causing water leaking.
Housing
Stator
Figure 4.8 Stator mounting interface
Deburring and rounding
Figure 4.9 Housing mounting interface
HIWIN MIKROSYSTEM Corp.
4-13