Table of Contents
Advertisement
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. A HMI575 high intensity
discharge lamp is included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L a mp I n s t a l l a t io n
1. Unscrew thumbscrews (S1) to detach the
top cover.
2. Unscrew screws (S2) to remove lamp
cover and expose lamp compartment.
3. If installing a new lamp, loosen both
screws on the double ended lamp to
allow for the lamp to slide into the lamp
socket slots. Lower lamp evenly.
4. If replacing a lamp, loosen both lamp
screws (S3) to relieve tension from
lamp socket slots so you can slide the
lamp freely, upwards and out of lamp
socket. Raise lamp evenly to remove.
5. Before you tighten the lamp end screws, rotate the
bulb until the nipple on the envelope (N) of the bulb
is facing upwards as illustrated.
6. If you are replacing the lamp, you may want to log
the fixture hours in order to track the lamps use.
Navigate to the {LPti} on the menu display to obtain
this information. (Page 14, Control Board Functions)
LEG-5000X User Manual
1
2
3,4
5
N
7
S1
1
S2
2
S3
Revision: 2007-03-08/17:20
Advertisement
Table of Contents
