Table of Contents
Advertisement
Replacing Gobos
1. Unscrew thumbscrews (S1) to detach
the top cover.
2. Remove screws labeled (S2) and
pull out air channel guide (A1) to
allow more space for the
replacement of gobos.
3. Rotate the gobo wheel so
that the gobo to be replaced
lies in the center of the "U"
shaped opening.
4. Press both tips of the gobo tension ring
together and remove from the gobo
aperture.
5. Push the gobo with your finger from the
back side following the same direction that
the tension ring was removed.
Caution!
Tension ring could pop out abruptly
and fall inside the fixture. Please use
caution when removing and if
necessary use both hands.
NOTE!
Replacing the gobos on the static gobo wheel is achieved using the same
method as the rotating gobo wheel. However, the spring needs to be
removed first using a small flat head screw driver before pushing the gobo
out of the aperture.
LEG-5000X User Manual
1
A1
2
3
9
S1
S2
"U" shaped opening
Gobo tension ring
Revision: 2007-03-08/17:20
2
Advertisement
Table of Contents
