Table of Contents
Advertisement
4.14.6 Parameter setting of X Y Z-axis and speed axis
X-axis parameter
Three-level menu, press "PROG" key to enter to modify the X-axis parameter.
Y-axis parameter
Three-level menu, press "PROG" key to enter to modify the Y-axis parameter.
Z-axis parameter
Three-level menu, press "PROG" key to enter to modify the Z-axis parameter.
Speed axis parameter
Three-level menu, press "PROG" key to enter to modify the speed axis parameter.
4.14.7 Parameter setting of X-axis
Sensor
Setting of sensor type. Press "PROG" to enter the menu, there are several digital sensor types
selectable.
MS100 ; MS200 ; MS500 ; CSA010 ; CSA020 ; CSA050
Use the sensor setting MS200 for reading heads in scope of delivery of DRO5.
Resolution setting
Press "PROG" key to enter and choose.
For sensor type „MS200" , there are 4 possibilities to choose from. 2µm ǀ 5µm ǀ 10µm ǀ 50µm
Use a resolution of 50 microns for the magnetic tapes with the item no. 3383978 or 3383979 or
3383980 .
Other magnetic tapes from other manufacturers, or magnetic tapes with another item number
can have a different resolution.
Setting counting direction
Press the "PROG" key to enter the menu. "+/-" as a select.
Setting display mode
Press the "PROG" key to enter the menu. "On / Off" as a select.
Linear error compensation
Press the "PROG" key to enter the menu, use ↑ ↓ ← → keys to modify, then press the
"PROG" key to exit.
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to section 4.14.6
INFORMATION
The parameter setting of Y, Z-axis is the same as X-axis.
4.14.8 Parameter setting of speed axis
Teeth amount of every turn (pulses per rev)
Press "PROG" key to enter, selection range is 1~36, the increment or decrement is 1.
Display mode
Press the "PROG" key to enter the menu, "On / Off" as a select.
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to section 4.14.6
Version 2.5.1 - 2020-07-28
Translation of original instructions
DRO 5
GB
37
Advertisement
Table of Contents
