Table of Contents
Advertisement
3.5
Lifting the machine
WARNING!
Danger of crushing and overturning. Proceed carefully when lifting, installing and
assembling the machine.
Fix the load lifting gear around the drilling-milling head. Use a lifting strap with a width of 30
mm to do this.
Lock all clamping levers on the drilling-milling machine before you lift it.
Make sure that no add-on pieces or varnished parts are damaged due to the load suspen-
sion. To prevent the possibility of damage occurring to the cap of the drive and to the milling
head, the load step should be selected on the guide of the milling head. The bellows must
be removed to do this.
Take care with the centre of gravity of the machine.
3.5.1
Assembly
Organise the working area around the machine according to the local safety regulations. The
work area for operation, maintenance and repair must not be restrictive.
Follow the prescribed safety areas and escape routes according to VDE 0100 part 729 as
well as the environmental conditions for the operation of the machine.
The mains plug of the milling machine must be freely accessible.
The machine must only be installed and operated in a dry and well-ventilated place.
Avoid places near machines generating chips or dust.
The installation site must be free from vibrations also at a distance of presses, planing
machines, etc.
Provide sufficient space for the personnel preparing and operating the machine and trans-
porting the material.
Also make sure the machine is accessible for setting and maintenance works.
Check that the milling machine foundation is horizontal with a spirit level.
Check that the foundation has sufficient load-bearing capacity and rigidity.
Version 2.5.1 - 2020-07-28
Translation of original instructions
Centre of gravity
MH20V | MH20VL | MH20VLD
GB
25
Advertisement
Table of Contents
