Table of Contents
Advertisement
10)
Install the Left Rear Cover.
• 5 Claws
• 2 Screws
• 2 Rubber Caps
11)
Connect the Reader Power Supply Cable.
• 2 Connectors
• 2 Wire Saddles
• 1 Cable Guide
NOTE:
•
Connect the Reader Power Supply Cable from the connector side, and leave the slack at
the [A] part.
•
Bend the Reader Power Supply Cable at a right angle at the [B] part.
x2
Wire Saddles
6
Installation > Installation Procedure
[A]
Cable Guide
[B]
Reader Power Cable
Connectors
F-6-30
6
Installation > Installation Procedure
12)
Open the Right Lower Cover, and install the Right Rear Cover 1.
• 1 Screw (RS Tightening; M4)
• 2 Screws (TP; M3)
• 1 Claw
CAUTION:
• Check the Reader Power Cable is in the front side.
• Put the [A] part into [B] area of the Right Rear Cover.
[B]
13)
Close the Right Rear Cover 1, the Right Upper Cover and the Right Lower Cover.
6-12
[A]
F-6-31
6-12
Advertisement
Table of Contents
