4
Parts Replacement and Cleaning Procedure > Clutch Solenoid Motor Fan PCB (ADF) > Removing the LED PCB (PCB3)
4) Remove the clutch
- Resin ring 1 pc
- Bearing 1 pc
CAUTION:
Install the pickup clutch with the clutch gear (white) aligned with the mark "W" (white)
on the clutch support plate.
Install the registration clutch with the gear (black) aligned with the mark "B" (black) on
the clutch support plate.
White
CL1
W
4
Parts Replacement and Cleaning Procedure > Clutch Solenoid Motor Fan PCB (ADF) > Removing the LED PCB (PCB3)
Black
CL2
B
F-4-53
Removing the ADF Driver (PCB1)
1) Open the feeder cover.
2) Remove the rear cover and rear small
cover."Removing the Rear Cover"(page 4-16).
3) Remove the ADF driver PCB.
- Connector 12 pcs (ALL)
- Screw 2 pcs.
x12
x2
Removing the LED PCB (PCB3)
1) Open the feeder cover.
2) Open the ADF.
3) Remove the front
cover."Removing the Front Cover"(page 4-15).
4) Close the ADF.
5) Remove the inner
cover."Removing the inner cove"(page 4-17).
6) Remove the different width sensor holder.
- Screw 3pcs.
x3
4-24
F-4-54
F-4-55
4-24
Need help?
Do you have a question about the Color Image Reader-F1 and is the answer not in the manual?