Xinje XD Series User Manual page 281

S3+17 PID max output
S3+18 PID min output
S3+19 Last time sampling time
S3+20 Actual sampling time
space
S3+22 Last time user set target
temperature
S3+23 -
The following is the joint address (divided into step setting, critical oscillation setting and
Step part (read only parameters, only for monitoring)
S3+24 Actual sampling space
S3+26 Operating segment of
auto-tuning PID
S3+28 Duration of auto-tuning
PID operating
parameters
S3+30 Real-time accumulation
of two inflection points
10: Critical oscillation mode
Bit8：
0: manual control status
1: auto tune end, enter manual
control status
0～32767
0～32767
0~sampling time (unit: ms)
The value is around the
sampling time
The value before changing the
target temperature
-
manual control)
0～4294967296 (unit: ms)
0: Preparation stage
1～2: auto tune parameter
collection
3: calculate PID parameters
0～4294967296 (unit: ms)
Clear and recalculate the time
when reaching the inflection point
0～4294967296 (unit: ms)
280
monitoring purposes
only
Internal use
parameters of the
system for
monitoring purposes
only
Internal use
parameters of the
system for
monitoring purposes
only
16-bit no sign,
Internal use
parameters of the
system for
monitoring purposes
only
32-bit no sign,
Internal use
parameters of the
system for
monitoring purposes
only
Internal use
parameters of the
system for
monitoring purposes
only
Parameter is
reserved
Internal usage
parameters of the
system
Internal usage
parameters of the
system
Internal usage
parameters of the
system
Internal usage
parameters of the
system