CANOPY
HATCH
Step 3. Thread the wires from the ceiling through
the opening in the canopy gasket. Attach the
canopy to the crossbar mounting bracket with three
1
of the 8-32 x 2
long canopy screws and canopy
/
4
lock washers.
Using the screwdriver, tighten the screw firmly by
hand only.
Note: On sloped ceilings, align the
canopy opening toward the top or
room peak.
Step 4. To hang the fan body in the
canopy, hold the fan body firmly and in-
sert the ball into the canopy opening.
Check that no wires were pinched. Ro-
tate the fan body until the slot in the
ball fits into the pin opposite the canopy
opening.
Step 5a. Attach the fan wires to the ceiling fixture outlet
box wiring by placing the bare ends of the wires side by side
and then securing with a wire nut. Test that the connection
is secure by pulling on the wire nut. Connect in this order:
Step 5b.
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLUE wire and BLACK power wire from fan to BLACK power
wire in ceiling outlet box. Secure with wire nut.
CANOPY HARDWARE
CANOPY
CANOPY INSTALLATION
HANGING THE FAN
CANOPY ELECTRICAL CONNECTIONS
L
CANOPY SCREW (4)
CANOPY LOCK WASHER (4)
CANOPY GASKET,
HANGING PLATE, &
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY LOCK
WASHERS
CANOPY
SCREWS
BALL
CAPPED
BLUE
D1-OPTION
WIRE.
SLOT
WIRE NUT
2 BLACK WIRES
2 WHITE WIRES
3 GREEN WIRES
ANAI
CANOPY
PIN
5