Crossbar Mounting Bracket Installation; Canopy Hardware; Canopy Installation - Casablanca Victorian Owner's Manual

CROSSBAR MOUNTING BRACkET INSTALLATION

proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the
bracket, with ground wire and ridges down, to the ceiling
fixture outlet box with the mounting hardware included with
the outlet box.
Tighten the screws firmly by hand only, being careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
canopy
hatch
Step 2. Attach the canopy to the crossbar mount-
ing bracket with three of the 8-32 x 2
canopy screws and canopy lock washers.
Tighten the screw firmly by hand only.
noTe: On sloped ceilings, align the
canopy opening towards the top or
room peak.
4
CEILINg FAN
wIRINg BOX

CANOPY HARDWARE

canopy

CANOPY INSTALLATION

" long
1
/
4
approVeD
CEILINg
wIRINg
CROSSBAR
mOUNTINg
BRACKET
FLAT
Washer
approVeD
OUTLET BOX
harDWare
canopy lock Washer (4)
canopy
canopy lock
Washer
canopy
SCREw
RIDgE
SIDE
DOwN
gREEN
gROUND
wIRE
canopy screW (4)
CROSSBAR
mOUNTINg
BRACKET