Preparation Instructions; Fan Preparation - Casablanca Lanai Owner's Manual

Casablanca lanai ceiling fans: owners manual

Hide thumbs Also See for Lanai:

Service manual (15 pages)

Table Of Contents

Table of Contents

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them

against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.

ALLEN SET SCREW

⁄

-20 x

⁄

(PRE-INSTALLED)

Step A. Slide the downrod gasket onto the downrod as shown,

pushing the gasket so that it is snug with the ball of the

downrod.

IMPORTANT SAFETY INFORMATION!

BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE

THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY

Prepare for fan installation as follows:

Step B. Route the wires from the motor through the

Perma • Lock™ downrod and ball assembly.

Tip: The downrod has a tapered thread

that is designed to lock completely when

correctly installed.

Step C. Using the provided allen wrench, loosen the set screw

several turns to allow installation of the downrod. Thread

the downrod into the motor coupling until it stops turning,

this will take at least four and a half full turns.

Step D. Securely tighten the set screw with the provided allen

wrench to ensure safe operation of your fan.

CAUTION: Failure to fully lock in the down-

rod before securely tightening the allen set

screw may cause the fan to separate from

the downrod during normal operation!

Step E. Slide the downrod gasket down so that it fits snugly

against the motor casing as shown.