Crossbar Mounting Bracket Installation; Canopy Hardware; Canopy Installation - Casablanca Metropolitan Owner's Manual

CROSSBAR mOUNTINg BRACKET INSTALLATION

Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the 'Approved For Ceil-
ing Fan Installation' ceiling fixture outlet box with the outlet
box mounting hardware.
Tighten the screws firmly, being careful not to bend the
bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CANOPy
HATCH
Step 2. Attach the canopy to the crossbar mount-
ing bracket with three of the 8-32 x 2 ½" long
canopy screws and canopy lock washers. Hand
tighten until snug against the ceiling.
note: On sloped ceilings, align the
canopy opening towards the top or
room peak.
4
CEILINg FAN
APPROvED
WIRINg BOX
CEILINg
WIRINg
CROSSBAR
mOUNTINg
BRACKET

CANOPy HARDWARE

CANOPy LOCk WAsHER (4)
CANOPy

CANOPy INsTALLATION

CROSSBAR mOUNTINg
BRACKET INSTALLED
FLAT
WASHER
APPROvED
OUTLET BOX
HARDWARE
CANOPy sCREW (4)
CANOPy
CANOPy LOCk
WASHERS
CANOPy
SCREWS
RIDgE
SIDE
DOWN
gREEN
gROUND
WIRE