Canon CXDI-60G Service Manual page 70

2. Installation Manual
D) After setting the output destinations, follow the procedure below to check
whether images can actually be transmitted. Return to the user menu, capture
a sample image (one X-ray image), and transmit the image to the printer and
storage. There are two errors that may result if the image cannot be
transmitted:
a. "DICOM Connect Error. Cannot connect to the target. Check network or port
number setting. Retry?"
b. "DICOM Transfer Error. Error occurred during the association. Retry?"
Message (a) indicates that connection at the TCP/IP level is not possible and that
the physical connections or the subnet mask and other settings must be checked
again.
Message (b) indicates that communication at the TCP/IP level is problem-free but
that DICOM level communication has failed. In this case, check again that
AE_TITLE of CXDI has been sent properly to the transmission destination and
that the IP address, port number and AE_TITLE of the transmission destination
which are set with CXDI have been set properly.
* "AE_TITLE" of the transmission destination is case sensitive fields.
(Permit upper-case letter or lower case letter, etc)
54