Canon CXDI-60G Service Manual page 55

(2) Checking the Firmware Version
1) Purpose
1-1) Failing to use the proper versions of the firmware and PLD code with the CXDI
software can result in an error, and system operation cannot be guaranteed. Therefore,
the versions of the firmware must be checked to ensure that they are correct.
2) Notes
2-1) This check should always be performed at installation, and if necessary, the firmware
versions should be upgraded.
2-2) This check cannot be performed with only the control computer. Connect the imaging
units and other equipment, and start up in the normal imaging status.
3) Procedure
3-1) Checking the firmware alone
a. Start up the CXDI software.
b. Display the version information from the user mode.
SYSTEM > SETUP MENU > VERSION INFORMATION
c. Confirm the firmware version.
[System Module: Version Information]
A. Hardware version
Product type: Product type is identified from Sensor serial No. that is set to the Imaging
unit. 0b.** indicates 60G and 0f.** indicates 60C.
B. Firmware initialization code version
This is the version of the initialization code written on the PWB-60Di. Initialization code
will be downloaded and settings will be reset to the default (factory) settings by turning
ON the power while pressing the initialization switch on the power box.
The display "3.0.08" on the screen indicates the version 3.00.08.
C. Firmware normal code version
This is the version of the normal code installed on the PWB-60Di. Usually the system
operates with this code. It must be updated as required.
The display "3.0.08" on the screen indicates the version 3.00.08.
2. Installation
A B
39
C