5603, 5600 And 5605 Vision System Specifications - Cognex In-Sight 5000 Series Installation Manual

5603, 5600 and 5605 Vision System Specifications

Table 3-3: 5603, 5600 and 5605 Vision System Specifications
Specification
Minimum Firmware
Requirement
Job/Program Memory
Image Processing
Memory
Sensor Type
Sensor Properties
Maximum Resolution
1
(pixels)
Electronic Shutter
Speed
Acquisition
Bit Depth
2
Frames Per Second
Lens Type
Lens Cover View Port
Material
Trigger
Discrete Inputs
Discrete Outputs
Status LEDs
Network
Communication
4
1588 Support
Serial Communication RS-232C when connected to the Breakout Cable or a compatible I/O module. (For more
Power Consumption
Material
Finish
1
The number of image sensor rows are configurable and can be set within the In-Sight Explorer software. Decreasing the number of rows will
increase the number of frames per second acquired by the vision system. Refer to the AcquireImage topic in the In-Sight
for more information.
2
Maximum frames per second is job-dependent, based on the minimum exposure for a full image frame capture using the dedicated acquisition
trigger, and assumes there is no user interface connection to the vision system.
3
To ensure reliable communication using 1000 BaseT operation, the Ethernet cable must not exceed 75 meters (from the vision system to the
endpoint).
4
1588 is only supported on vision systems running firmware version 4.5.0 and higher.
5603/5613
In-Sight version 4.4.3
128MB non-volatile flash memory; unlimited storage via remote network device.
256MB SDRAM
1/1.8-inch CCD
8.8mm diagonal, 4.4 x
4.4µm sq. pixels
1600 x 1200
27µs to 1000ms
Rapid reset, progressive scan, full-frame integration.
256 grey levels (8 bits/pixel).
14 full frames per second.
C-mount
Clear plastic with an abrasion-resistant coating on the exterior side.
1 opto-isolated, acquisition trigger input. Remote software commands via Ethernet and RS-
232C.
None built-in. Additional inputs available using a compatible I/O module. (For more
I/O Modules on page 4
information, refer to
system.
2 built-in, high-speed outputs. Additional outputs available using a compatible I/O module. (For
more information, refer to
I/O system.
Power, Network Status, Network Traffic, 2 user configurable.
1 Ethernet port, 10/100/1000
DHCP (factory default), static and link-local IP address configuration.
Timestamp Resolution: 8ns
Synchronization Accuracy Through Transparent Clock: 5µs
I/O Modules on page 4
information, refer to
24VDC ±10%, 600mA maximum.
Die-cast aluminum housing.
Painted/Powder coat (back plate).
5600/5610
1/3-inch CCD
5.92mm diagonal, 7.4 x
7.4µm sq. pixels
640 x 480
32µs to 1000ms
60 full frames per second.
.) Unlimited inputs when using an Ethernet I/O
I/O Modules on page 4
.) Unlimited outputs when using an Ethernet
3
BaseT with auto MDIX. IEEE 802.3 TCP/IP protocol. Supports
.)
Specifications
5605/5615
In-Sight version 4.4.1
2/3-inch CCD
11.01mm diagonal, 3.45 x 3.45µm
sq. pixels
2448 x 2048
28.8µs to 1000ms
16 full frames per second.
®
Explorer Help file
13