I/O Modules - Cognex In-Sight 5000 Series Installation Manual

I/O Module Cable
The I/O Module cable connects the vision system directly to a compatible In-Sight I/O module via the DB15 connector.
The pin-outs for the cable are listed in the
lengths listed below.
Table 1-5: I/O Module Cable Lengths and Styles
Length Standard Part #
2 m CCB-84901-0901-02
5 m CCB-84901-0902-05
10 m CCB-84901-0903-10
15 m CCB-84901-0904-15

I/O Modules

The following I/O modules are compatible with your vision system, and provide access to additional discrete inputs and
outputs.
Table 1-6: I/O Module Compatibility
I/O Module
CIO-1400
CIO-MICRO and CIO-MICRO-
12
CC
1
The CIO-MICRO and CIO-MICRO-CC I/O modules do not support 1000 BaseT pass-through operation. If 1000 BaseT operation is required
when using the In-Sight 5600 series vision system, you must connect a LAN cable from a Gigabit Ethernet switch to the I/O module's LAN port
and connect the vision system's Ethernet cable to the Gigabit Ethernet switch.
2
The CIO-MICRO-CC I/O module also adds CC-link networking capability. Refer to the In-Sight
Module Installation Manual for detailed connection information.
3
The CIO-MICRO & CIO-MICRO-CC I/O modules support In-Sight 5100 series and 5400 series vision systems with 128MB non-volatile flash
memory or higher and support all In-Sight 5600 series vision systems.
4
I/O Module Cable Specifications on
Figure 1-3: I/O Module Cable
45-Degree Key Right-Angle Part #
CCB-84901-4001-02
CCB-84901-4002-05
CCB-84901-4003-10
CCB-84901-4004-15
Vision System
All In-Sight 5000 series vision systems
(except In-Sight 5604)
All In-Sight 5000 series vision systems
page 23. This cable is available in the
35-Degree Key Right-Angle Part #
CCB-84901-5001-02
CCB-84901-5002-05
CCB-84901-5003-10
CCB-84901-5004-15
Discrete Inputs
7 general
3
8 general
®
CIO-MICRO and CIO-MICRO-CC I/O
Discrete Outputs
2 high-speed,
6 general
2 high-speed,
8 general