Installing The Software; Run The Setup Screen - Canon MultiPASS MP360 Software Manual

Installing the software

Run the setup screen

When you install the software, all the software you need is installed on your local hard disk drive.
IMPORTANT IMPORTANT IMPORTANT
• Do not install the software on the network drive.
• If you have an older version of the MultiPASS Suite software installed on your computer, delete this
version before installing the new version.
• When installing the software in Windows 2000/XP, you must log on as Administrator or have
Administrator privileges.
NOTE
If there is a copy of the software on the local or network drive, you can install from the drive on which the
software is copied without using the Setup CD-ROM.
1
Turn on the machine.
2
Turn on your computer.
IMPORTANT
• Do not connect the machine to the computer with the USB cable until instructed to do so.
• If the machine is connected to your computer, the [New Hardware Found], [Device Driver
Wizard], [Add New Hardware Wizard] etc. screen appears. In this case, disconnect the USB
cable, then click [Cancel] on the screen.
3
Quit any applications (including virus checkers) that are currently running.
4
Insert the Setup CD-ROM into your disk drive.
The [Setup] screen is displayed.
Install the software by following in order steps 1, 2 and 3 as displayed in the [Setup] screen.
If this screen is not displayed, on the Windows desktop, double-click [My Computer] (Windows XP:
Click [Start], then click [My Computer]). Open the CD-ROM icon, then double-click
[Setup (Setup.exe)].
If you are installing from a copy saved on a network or hard disk, double-click [Setup (Setup.exe)] in
the copy.
[Setup] screen
6