Reading From Or Writing To A Memory Card; Enabling/Disabling Overwriting Memory Card Data - Canon MultiPASS MP360 Software Manual

Reading from or writing to a memory card

When the machine is connected to a computer, the memory card drive (Removable Disk) will
appear under [My Computer] on the Windows desktop.
By inserting a memory card in the machine, you can view photographs on the memory card by
opening the [Removable Disk] on your computer. You can then copy the photographs to your
computer's hard disk (similar to copying other files on the hard disk), or by changing the setting,
can copy hard disk files onto the memory card.
IMPORTANT IMPORTANT IMPORTANT
• Do not put your computer in standby or sleep mode when a memory card is inserted in a card slot.
Also, do not remove or switch memory cards when your computer is in standby or sleep mode.
• When switching memory cards, press [ON/OFF] to turn off the machine before removing the card.
• In Windows 2000, if you turn off the machine, the [Unsafe Removal of Device] screen will be displayed.
In this case, click [OK]. This will not affect the machine or computer's operation.
• While accessing to the storage, do not remove the memory card, or do not disconnect the USB cable.

Enabling/disabling overwriting memory card data

You can enable or disable overwriting memory card data.
Follow the steps below to change the setting:
IMPORTANT IMPORTANT IMPORTANT
Windows 2000: If the <CARD PROTECT> setting for the machine is not recognized on your
computer, a delayed write failed error may occur while you copy data to a memory card, and data
may be broken.
1
Make sure there is no memory card inserted in the machine.
2
Press [Additional Functions].
3
Use [ ] or [ ] to select <5.CARD PROTECT> (MP390: <7. CARD PROTECT>).
4
Press [OK/Set].
CARD PROTECT
5
Use [ ] or [ ] to select <ON> or <OFF>.
6
Press [OK/Set].
Press [Stop/Reset] to switch to standby mode.
7
Press [COPY] or [SCAN] to select a mode.
You cannot overwrite in PHOTO mode.
8
Insert a memory card into the appropriate slot.
NOTE
If you change the above setting while a memory card is inserted in a card slot, disconnect and then reconnect
the USB cable to apply the new setting. The new setting will not be activated until you do so.
ON
15